Dream Steam Model Railways

MSS Mamod Upgrades - Water Top-up Valve

£9.00
Account Holders Earn 9 Loyalty Points
Thread
+
Ref:
DSUPWTV26
Brand
Dream Steam Works
Type
Upgrade Part
Gauge
16mm
Dream Steam Works

To take advantage of the extra running time of the Meths Burner, this Water Top Up Valve allows water to be pumped into the boiler a little at a time during running without having to take the Safety Valve off. Use with high temperature plastic feed pipe fitted to a water pump bottle or a large syringe.

Available in 1/4 x 26tpi thread for MSS and early Mamod standard loco boiler or 1/4 x 40 tpi for our Premium High Pressure Boiler.

Replacement Silicone - comes in 1 inch lengths to be cut down as required.

Also Bought
Customer Reviews
Write a Review and share your opinions!
3 Reviews:

Makes filling easy
Rating:
20 May 2024  |  Tom

As I already had another safety valve fitted to the boiler, I could fit this in place of the original and benefit from easier filling of a hot boiler. Quick and easy ordering very prompt dispatch, good service.

 
Was this helpful to you?  Yes  /  No

Top up valve
Rating:
09 October 2023  |  Roger

I purchased a top up valve from yourselves to fit on my Mamod traction engine as I have upgraded the burner that now far outlasts the water. It was easy to install replacing the whistle it has made a big difference to the running as the water is replaced a little at a time till the gas runs out a recommended improvement

 
Was this helpful to you?  Yes  /  No

Good Useful Item
Rating:
15 July 2010  |  Chay

This item is a very useful wayt of toping the water up in the boiler on the move. very useful in the older mamod locos as they have a smaller boiler then the new locos and run out of water in about 15 mins.

58 of 82 people found this review helpful.
Was this helpful to you?  Yes  /  No